#Spectrum mac address filtering how to

In the AP radio list, click View Drawing in the Operation column. View AP spectrum on the web platform to learn AP channel interference in deployment sites.Ĭhoose Monitoring > Spectrum Analysis.The 5G radio configuration is similar and not mentioned here. On the Radio 0 Settings(2.4G) page that is displayed, set the radio parameters. # Enable scanning, and configure the scan channel The air scan profile configuration page is displayed. Scan Profile page that is displayed, enter the profile name wlan-airscan and click OK. # Choose 2G Radio Profile > Air Scan Profile. Create an air scan profile and configure the scan channel set, scan interval, and scan duration.In the dialog box that is displayed, click OK. The 2G radio profile configuration page is displayed. On the Create 2G Radio Profile page that is displayed, enter the profile name wlan-radio2g and click OK. Choose Radio Management > Radio 0 > 2G Radio Profile. # Choose Configuration > AP Config > AP Group > AP Group. The configuration of a 5G radio profile is similar.

The following example configures a 2G radio profile. VLAN are not allowed between the AC and APs. VLAN are transmitted between the AC and APs. VLAN and service VLAN cannot be the same. In tunnel forwarding mode, the management If port isolation is notĬonfigured and direct forwarding is used, a large number of unnecessaryīroadcast packets may be generated in the VLAN, blocking the network Of a Large Number of Low-Rate Multicast Packets on the Wireless Network?.Ĭonfigure port isolation on the interfaces

See How Do I Configure Multicast Packet Suppression to Reduce Impact

#Spectrum mac address filtering how to

Packet suppression in traffic profiles of the AC.įor details on how to configure traffic suppression,

In tunnel forwarding mode, you are advised to configure multicast.

Packet suppression on switch interfaces connected to APs.

In direct forwarding mode, you are advised to configure multicast.

Otherwise, the multicast services may be affected. Exercise caution when configuring the rate limit To reduce impact of a large number of low-rate multicast packets on You are advised to configure multicast packet suppression Such multicast packets are sent from the network side, the air interfaces Packets, they are usually sent at low rates. To ensure stable transmission of multicast For multicast packet transmission on air interfaces.